Easily adapt to most cars. Complete with mounting plate and hardware. May require drilling and fitting. (Intended for light use only.)

In just minutes you can pull out your old oil pump without damaging your engine case with this simple to use oil pump puller. For 6mm & 8mm pump bodies.

VW FLYWHEEL LOCK TOOL

This Volkswagen universal flywheel lock woks on both 6 and 12 volt flywheels. Bolting through the engine case, it locks the flywheel securely in position for removal and installation of the gland nut.

Removal tool for the hard to reach oil filler nut on Type 1 VW engines.

Easily remove the distributor drive gear from your air cooled Volkswagen with this distributor drive puller tool.

VW carb syncronizer tool, same as "UNI-SYN." Use on almost any multiple carburetor setup to balance flow on each carburetor for best performance.

36mm axle nut removal tool commonly known as a "wacker" because you wack it with a hammer to remove the axle nuts. 36mm size for Type 1 & Type 3 Ghia. Use with 1/2" torque wrench to tighten nut.

46mm axle nut removal tool commonly known as a "wacker" because you wack it with a hammer to remove the axle nuts. 46mm size.

VW OIL FILLER NUT TOOL

1/2" Drive

Easily remove and install oil filler with this tool

EMPI 5763 VW BUG GOLF ENGINE HEAD VALVE GUIDE INSTALLER TOOL 8MM

Compress piston rings with a common pliers for easy piston installation on your VW.

Compress piston rings with a common pliers for easy piston installation on your VW.

36MM GLAND/AXLE NUT SOCKET

This 12 point 36mm Gland/Axle nut socket  is used to remove flywheel/gland or axle nuts along with your breaker bar.

VW BUG 17mm TRANSMISSION TRANSAXLE DRAIN PLUG SOCKET

6 SIDES

 3/8" DRIVE

ALSO USE ON IRS REAR TRAILING ARM PIVOT BOLTS

.25LBS

12-point 8mm hex, 3/8" drive

Socket style 1/2 - 20 chrome VW wheel locks. Set of 4.