EMPI 5002 Oil Pump Puller
In just minutes you can pull out your old oil pump without damaging your engine case with this simple to use oil pump puller. For 6mm & 8mm pump bodies. $9.95
|
VW FLYWHEEL LOCK TOOL
This Volkswagen universal flywheel lock woks on both 6 and 12 volt flywheels. Bolting through the engine case, it locks the flywheel securely in position for removal and installation of the gland nut. $12.95
|
Easily remove the distributor drive gear from your air cooled Volkswagen with this distributor drive puller tool.
$49.95
|
VW carb syncronizer tool, same as "UNI-SYN." Use on almost any multiple carburetor setup to balance flow on each carburetor for best performance.
$29.95
|
EMPI 5748 Axle Nut Tool 36mm
36mm axle nut removal tool commonly known as a "wacker" because you wack it with a hammer to remove the axle nuts. 36mm size for Type 1 & Type 3 Ghia. Use with 1/2" torque wrench to tighten nut. $21.95
|
46mm axle nut removal tool commonly known as a "wacker" because you wack it with a hammer to remove the axle nuts.
46mm size. $21.95
|
VW OIL FILLER NUT TOOL
1/2" Drive
Easily remove and install oil filler with this tool $15.95
|
EMPI 5763 VW BUG GOLF ENGINE HEAD VALVE GUIDE INSTALLER TOOL 8MM
$13.90
|
|
Compress piston rings with a common pliers for easy piston installation on your VW.
$9.99
|
Compress piston rings with a common pliers for easy piston installation on your VW.
$9.99
|
36MM GLAND/AXLE NUT SOCKET
This 12 point 36mm Gland/Axle nut socket is used to remove flywheel/gland or axle nuts along with your breaker bar. $15.95
|
VW BUG 17mm TRANSMISSION TRANSAXLE DRAIN PLUG SOCKET
6 SIDES
3/8" DRIVE
ALSO FOR USE ON IRS REAR TRAILING ARM PIVOT BOLTS
$6.95
|
C.V. Joint Socket
12-point 8mm hex, 3/8" drive
$7.95
|
|
|
|
