VW Tools & Tow Bars
| Categories |
|---|
|
Easily adapt to most cars. Complete with mounting plate and hardware. May require drilling and fitting. (Intended for light use only.)
$97.99
|
In just minutes you can pull out your old oil pump without damaging your engine case with this simple to use oil pump puller. For 6mm & 8mm pump bodies.
$5.99
|
This Volkswagen universal flywheel lock woks on both 6 and 12 volt flywheels. Bolting through the engine case, it locks the flywheel securely in position for removal and installation of the gland nut.
$5.99
|
|
Easily removes VW distributor drive gear.
$43.00
|
VW carb syncronizer tool, same as "UNI-SYN." Use on almost any multiple carburetor setup to balance flow on each carburetor for best performance.
$24.95
|
36mm axle nut removal tool commonly known as a "wacker" because you wack it with a hammer to remove the axle nuts. 36mm size for Type 1 & Type 3 Ghia. Use with 1/2" torque wrench to tighten nut.
$8.50
|
|
12 point 36mm Gland/Axle nut socket - remove flywheel/gland or axle nuts with this socket and your breaker bar.
$6.99
|
6 point 36mm Gland/Axle nut socket - remove flywheel/gland or axle nuts with this socket and your breaker bar.
$6.99
|
12-point 8mm hex, 3/8" drive
$5.99
|
|
Magnetic drain plug for all Type 1 VW engines.
$3.99
|
Removal tool for the hard to reach oil filler nut on Type 1 VW engines.
$15.99
|
Compress piston rings with a common pliers for easy piston installation on your VW.
$3.99
|
|
|
